Aeron, as far as I know, SBIG AllSky camera doesn't use SBIG linux driver (libsbigudrv.so). That camera uses its own special I/O serial protocol...
Paul, I think if you run SbigDriverChecker, this should install all the necessary files, i.e. sbig driver including requested MS windows...
Hi Sendell, I didn't know you probably connected/disconnected I2C device - FW-8300 while powered which is not allowed, of course. Your "EzUSB Fx2...
Sendell, driver checker should be only used to install SBIG's universal driver, so I do not exactly understand what you are doing with the VID/PID...
Adam, I think, this is already explained in FAQ section under the How to Log debug messages, if you didn't change something inside the driver...
Jim, I think that the stfga.bin - gate array file is missing in your camera, but of course, I cannot be 100% sure. In any case, I would try that...
Rick, I would test it with different computer, not Trio tablet and classical power supply. Jan
Jim, this usually happens when the driver is badly installed. This type of camera downloads its firmware into its memory every time it starts, so...
Chris, I do not believe your camera is brick, maybe just improperly set. Please run CCDOps and check its basic configuration. Below are a few...
I am still running very long simultaneous test with STF-8300/FW5-8300 & ST-i cameras. Till now, it takes more then 8 hours and I took over 90.000...
Doug, maybe my answer was a bit unclear. I wanted to say, that my STF-8300 is running on a small Linux machine and that setup is remotely...
Doug, this may be really related to Windows 7 OS, because I did a lot of trials to get driver's error 8 with my remotely controlled STF-8300...
I am not quite sure, but it looks like analog board of your stf camera could be broken. I also have my stf with the same problem, its I/O board...
did your stf work previously with this setup ? Can you try different pc ? js
Robert, that's very strange. I would suppose this timeout problems has to happen only during communication with the camera. Jan
Robert, sbig driver itself is a collection of the lowest level routines which control individual parts of the camera like ccd chip, shutter, ao,...
hi, this is RX timeout error, just subtract 30000 or 1000 and you will get error code 8. See How To about err. codes. jan
Did your camera work previously ? I think your camera should communicate with your PC even if there is an original firmware (bf2 files) inside its...
Sorry, I am not an employee of DL since April 1st. 2015. For more info, contact me off line at astrosoft@email.cz j
Rodolphe, I think, Adam did some progress with signing Mac's driver(s) with their certificates. Jan
Separate names with a comma.