I checked the light and it remained green at full fan and full cooler. I am requesting an RMA. Thanks for your help.
Doug, you were correct as I tried reinstalling V15 before I saw this and although it succeeded it had no effect. I was looking for a way to check...
I was thinking about re-installing the firmware, unless you believe it would be pointless..
I also note that it is now powered up, cooler off, disconnected, on auto fan, -1C ambient, and the fan is varying between low and medium.
From the first posting… My FPGA Revision is 15, Wifi revision is blank, DLAPI is 2.7.1.0, Windows 10 up to date.
Last night I stared Maxim, set the fan to high, and connected the camera. The fan did not run on high. Readings were: Ambient -4C, set at -30C,...
-15C to -20C It is running now at -3C ambiant, set at -10C, 30% cooler, Heatsink 9C, fan steady on medium and I can still access the fan speed. I...
Last night I tried the things you mentioned. So starting with the camera powered up for 5 hours not connected to Maxim: 1) The fan, that was...
Camera SN: AC4040M-23110303. The fan has behaved like this from day one, which was about 4 months ago. It sounds good, like my BSI (like a plane...
Up until yesterday I have always run both cameras on auto fan. The BSI camera behaves smoothly. It’s the FSI whose fan speed varies from slow to...
I have a similar problem with my AC4040FSI. When the weather was warmer, the fan ran but was very irregular in its speed. I now find that in -20C...
PS: The board was le issue.
I dropped it off in person at the old location. Waiting for a call to pick it up from the new location very soon. Tim has been very good at...
Camera sent for repairs. Many thanks.
I tried the above, as well as using my laptop, no device shows up. A TeamViewer would be much appreciated. I will email you my contact information.
I have 2.7.1.0. I followed the instructions and updated these just before the update.
My camera was running Rev13 and I attempted to update it to Rev15. The process completed successfully, and requested a power cycle. The power was...
I reduced the High Gain to 1400, reduced the ADU to 10% on the flats, took 20 each of darks and flats, and all the craziness is gone! Albeit on...
I found this online which I think is my problem: “When using the ASCOM V2 driver with either ASCOM Direct or Telescope guide methods in MAXIM, you...
Thank you both for this information. On my next visit to my observatory, will add the following changes to my work flow: 1) Reduce the ADU count...
Separate names with a comma.