No, I machined my own OAG unit Colin. I put a 1.25" reducer just above the pick off prism to give me a larger guiding FOV also. Regards Joshua
Thanks Colin. I'm using the AOX with the stl11k and the remote guide head. So Yes, I will make sure it's the same as the short one supplied, and...
I need to purchase a new serial cable to go between the STL11K I2C port and the AOX "I2C in" port. The cable I used last time (not supplied by...
Thanks Colin, I will send Bill an email. Josh
I will open up The Filter wheel compartment to make sure The motor is making contact with The FW belt, while I'm there is there any test I can do...
Hello Colin. I did open up The back of The camera and checked this fuse, it is good. Are there any others? Thanks Josh
Hello Doug. Thanks for your reply, I did already try to operate The camera with CCDOPS, I get The same error message and problem. Are there by...
Hi there, Today I went to use my camera in TSX Pro, using the latest daily build, I get the filter wheel is busy error code 31001. I believe this...
Okay, Thanks for your replies Colin and Doug. That answers my question.
Hi Guys, I'm working out spacing in my imaging train, Is there a maximum distance that the OAX should be from the imaging chip? is further away...
No worries, Thanks Doug
Well I tried it out tonight, and I was able to guide with the AOL on the st2000 while imaging with the stl11k at the same time. Just thought id...
Interesting Doug... I seam to be getting conficting views here... I've still got to try it out with maxim dl... I'll do that tonight. I managed...
It appears this configuration will not work. To quote from the thread at software bisque "when using an SBIG camera with AO, the dual detector...
Thanks Doug... I'm going to keep trying tonight.
I did some googling and downloaded a SBIG product catalogue, i found this page in the catalogue, I have attached it to this post. It appears the...
Thankyou Doug.
No worries, i guess i could try it out stand alone without using the stl11k... just soley use the st2000, I'll do that. Thankyou. Are the stl...
Thankyou Colin. I may try that to see if my config would work with it.
Okay, thanks Doug. Well the st2000 qualifies then
Separate names with a comma.