MOVE command with Manual Control

Discussion in 'General' started by Geoff Hughes, Nov 1, 2017.

  1. Geoff Hughes

    Geoff Hughes Cyanogen Customer

    Joined:
    Nov 13, 2015
    Messages:
    59
    The output pin configurations on my guide cam do not align completely with the input configurations on my mount. The RA and Ground pins are aligned; the DEC pins are reversed. Can I correct this under MOVE -> Manual Control by selecting the option to reverse the Y coordinates? Is that the purpose of this option, to compensate for hardware mismatches? Thanks for any guidance.
     
  2. Colin Haig

    Colin Haig Staff Member

    Joined:
    Oct 27, 2014
    Messages:
    2,497
  3. Doug

    Doug Staff Member

    Joined:
    Sep 25, 2014
    Messages:
    6,269
  4. Geoff Hughes

    Geoff Hughes Cyanogen Customer

    Joined:
    Nov 13, 2015
    Messages:
    59
    Thanks! Makes sense but since I'm not getting autoguiding to work I had to eliminate that possibility.
     

Share This Page