STL remote guide head connection

Discussion in 'Demo User Tech Support' started by richard payne, Dec 26, 2017.

  1. richard payne

    richard payne Standard User

    Joined:
    Dec 26, 2017
    Messages:
    5
    Ok , I am trying to connect my STL remote guide head, on the Universal
    Settings box it is checked for remote and the connection switches to STL11000
    from USB automatically. It images from the main guide chip only . I start off with everything
    powered down,connect then power up and choose the settings. I'm using the latest Maxim DL.
    I know it's not a hardware issue as in The Sky X using the camera control it shows up
    and connects with no issues. I'm sure it's a setting issue in Maxim, any help is most
    appreciated.
    Richard
     
  2. Doug

    Doug Staff Member

    Joined:
    Sep 25, 2014
    Messages:
    6,163
  3. Doug

    Doug Staff Member

    Joined:
    Sep 25, 2014
    Messages:
    6,163
    For SBIG dual-sensor cameras (and when using remote guide heads / self-guiding filter wheels), you have to turn on the Dual Chip Mode check box on the Setup Tab.
     
  4. richard payne

    richard payne Standard User

    Joined:
    Dec 26, 2017
    Messages:
    5
    Doug, thanks it works! I figured it was something simple.
    Richard
     

Share This Page