By the way, Bill: I am the guy that sent in my STF 8300 a couple of times for the problem of getting half the light on the St-i. I finally figured...
Attached are the HalfBlack fits file, and the exposure after it which is normal. This happens when in Guiding tab: No calibration being used....
I don't have a fits file; when I zipped my Settings file I had several thousand guider images, so the file was over 1Gb. I deleted those images to...
OK, here is my Documents/Maxim DL6 folder. I did the whole folder, rather than just Settings. Again, I am running 6.20 Maxim. The brightening of...
I had updated drivers, etc last time. Rechecked drivers, it says firmware and drivers are up to date. Attached screen shots. [ATTACH] [ATTACH]...
So, is there a fix for this problem yet (the varying guider images from the St-i)? I upgraded to Maxim 6.20, and am still seeing problems. This...
I think I would like to get an RMA and send this in. The more I look at it, the more it seems clearly misaligned. Should I remove the filter...
Actually, I tried that. It didn't seem to work, maybe I missed something simple. For example, my chip is 324 pixels wide. I defined X dimensions...
I have attached 3 images showing the situation, although it is hard to see well in the images. Image1 and Image3 are two shots of the problem....
The equipment train is: Celestron Edge 11 Optec TCF-S Focuser for fine focusing of the system STF8300 with Filter wheel and OAG The OAG has the...
Joshua, is this fixed in 6.18 now for single star guiding? I am at 6.08, and of course don't want to buy the update unless I know it has the fix....
I am having a problem with my ST-i guider. It is part of the STF8300 package with the OAG and filter wheel. Basically, the camera does not line...
Hi, I think I am also having this problem. It has been going on for sometime, but recently has picked up dramatically in frequency. I can no...
I ust updated my camera drivers. I also looked at the camera firmware, which says I am out of date. However, it suggests NOT to update the...
Separate names with a comma.