This happened maybe a month or so ago. Colin offered to power cycle the camera, which I did, and at that time fixed the problem. I did power...
Vertical lines again. Image is 30" through a V filter. Maxim 6.50, DLapi 2.8. It did this some time ago, unplugging seemed to fix it. But this...
There are vertical lines across the whole frame. This is new, system DID NOT do this on 4/13, it DID on 4/16 (system last used 4/13). There have...
Thank you, the additions are certainly helpful.
Thank you, this is exactly what we were looking for.
Thanks Doug. I have been through the manual and information relating the gain settings is sparse. There is a high gain and a low gain setting,...
Can someone explain the two gain settings for an AC4040 camera? There is a high gain and a low gain setting. What exactly does each of these do?...
What are the right settings for this camera in regards to gain? Currently it is set to: High gain 1650 Low Gain 280 I am doing photometry...
Dumb question...is it possible to shut the fan off with the camera powered up? I was able to do this with my old ST10, but can't see a way to do...
I have contacted Tim. It looks like this is can be an issue with this camera, especially the early ones. And as you may recall this is one of...
I took the camera off the telescope...took image while able to look at chip. The shutter is two pieces, one of them does not open at all, the...
120" exposure aluma AC4040. You can see a nice wedged shaped center portion of the image where there are stars, but there are two wedges on the...
Thank you.
Here is a basic question...for photometry with the Aluma AC4040 camera, what setting is preferred...low gain, high gain, high gain stackpro...or...
It is supposed to...We have had virtually no rain this monsoon, well under 1" in July and August. That is dry even for us. We have had clouds...
OK. I have installed it...it seems to fixed the problem but I only have a little testing. I may be shutting down again, monsoon seems to be...
So the filter wheel is doing it's spinning and not finding filters...again AC4040/FW&-STX. It was doing this some months ago, filter wheel back...
I think the filter wheel is behaving properly, it is not staying out late and is in rehab... I ran a simple plan via ACP-RGB frames of M13 (still...
I think everything updated. Downloaded both updates, did NOT monkey with the firmware. I can talk to the camera and the filter wheel spins. It...
I am asking the same question as well...Mike
Separate names with a comma.
