Using MDL to monitor the camera, it goes through all the motions. Once the temp has been set, the power ramps up to 100%, the temp starts to drop...
I noticed my camera's cooling rising in temperature while the power dropping back to the 13% reading. Going to the dome room it was apparent the...
I updated Maxim and the drivers and firmware. I tested the camera/filter wheel over three separate nights without any duplication of the problem....
Any progress on this?
Here you go.
Yes, all manufacturer cables and power supplies. The bahaviour is the same whether or not I use a powered usb hub. Yes, dual chip mode for camera 1.
Just checking...
Has there been any progress on this? Got some expensive filters wanting to get in the game.
Adam, Yes, of course. When? Tom
I updated the firmware as suggested. Testing the next clear night had the same problem. The camera stopped with the "waiting for filter wheel"...
Colin, Yes, both the threading boxes were checked. Tom
Hi, My camera sits at "waiting for filter wheel" whenever I attempt to change the filter. The upper status window shows "Filter moving" and each...
I have run several nights using ACP without Maxim (Ver. 6.22) going down. I consider this closed. Thanks for the support. Tom
Tim, Thank you. My thanks to the entire SBIG team. Tom
Colin, The camera has been returned. The packing slip says parts were replaced. Do you know if the problem was actually duplicated? Tom
Colin, Do these install over the top of the existing code or do I need to uninstall anything? Tom
Thanks, I was just making sure that you received it.
Would like to verify you guys have received the camera.
Just bumping this. Has there been any progress with the fix? I've got an expensive software package just sitting here.
Done.
Separate names with a comma.
