Yes, no worries... Was just checking on the net what a ‘code 43’ is (as that’s what keep popping up in the Device Manager). I’ve already had...
Do I need to ‘Configure the Driver’ by choosing ‘I don’t care or don’t intend to use an ST Model Camera’ I’ve not delved into this area at all......
Hi Tim I’m back in the garage... I have hooked the camera up - still an unknown device and am trying to follow your last instructions... I can’t...
Camera details: See pic.
Thanks Tim for your help. It’s nearly 10pm here, so will try your ideas tomorrow evening when I get home from work. I do believe the unknown...
Should I try to re-install the firmware as I highlighted in that image...? Also followed someone’s advice on CN and check the central power pin -...
Update. Numerous power downs and back ups. Had one sequence with two half clicks, no red light and then the fan start. Last 4 try’s, the red light...
Another thing just noticed. Disconnected usb and powered down camera. On re-power, fan on but no red light... not even a bong now from the PC when...
I also have TeamViewer installed if you would rather check yourself!
I can also double check on the Mac later as that’s how I normally run the camera and have updated it via the Mac drivers in the past. Camera has...
Just reading through the ReadMe Info and also found the STF-8300 Firmware in the Driver Checker64 > 32 bit folder.... see pic. Not...
Camera connected, only did this half a click again. Red light on back illuminated. Fan on. An unknown device registered on the laptop. You’ll have...
Yes, updated the drivers. Nothing in the Firmware tab See...
Hi Tim Home now and in the garage, doing some diagnostics pre-dinner! In the device manager the PC laptop can see something, but it is...
Hi everyone. My looked after camera has just stopped working tonight. Owned since they came out, only been off the FSQ once or twice. Purchased...
Just getting back into imaging after a few years hiatus. I’ve got everything working and successfully guiding. Taken a few 10 and 20 min images...
Separate names with a comma.