Colin: Can the AC455 connect directly to the Primaluce Eagle6 Thunderbolt4 port? Which available adaptor is needed if any? Do you think it can...
BTW, is there a newer DL Imaging driver that does not just jump to 13% power and hold when you click 'Warmup" after run? Ken
Colin: I tried unplugging and using 'deoxit' on all cables/connectors. Still had the disconnection error/problem after clicking 'connect' in...
Tonight, I started my AL3200 camera with Maxim v6.5. Camera connected but when I turned cooler on, after a few seconds the camera disconnected...
Tim: I sent a private message. Ken
Initially received a power supply with my new Aluma 3200 that failed at the connector from the power supply to the extension cable. The...
Colin: I have an Aluma3200 and FW8G filter wheel. Everything works in MaximDL6.2. I've selected Maxim DL's Camera under TheSkyX Camera Setup as...
Trying to use my new Aluma3200 camera with TheSkyX camera add-on. I don't think I see Aluma series cameras/drivers listed. Are they available yet?...
The replacement nosepiece fits in my moonlite focuser! The camera is now installed. Rebalanced the scope a bit to account for new camera/filter...
Doug: I took out my caliper and did some measurements (10 replicate measurements each). It was an interesting exercise! First I measured the new...
I got my new filter wheel and camera set up. Finally, screwed in the 2 inch nosepiece supplied with the filter wheel. Unfortunately, when I tried...
The following maxim log error at 06:09:26 indicates an apparent temperature error? The camera (ST7XME) ran normally for 5 hours before aborting...
Separate names with a comma.
