I just installed 4.97 build 2 and ran the autoguider with SkyXPro and my ST-i for a couple of hours and no errors or timeouts occurred. I have yet...
Sign me up, please.
The link says I don't have the privilege to view Adam's post. Can you post it here?
"Are you able to tell what command was being executed when "Access Denied" was reported? The log line you provided is a little thin on context."...
Is there any update on this? Okie-Tex is coming up and I'd sure like to have this resolved before then.
Both the driver and the firmware. The SBIGUDrv.dll was dated 9/23/2014, and the firmware was dated 6/25/2013. These two had the timeout issue. The...
Doug, until I have an chance to test out the earlier version with my hardware, we cannot be sure the older driver did not resolve the issue. But...
Rolling back to SkyX version 9334, and an earlier version of CCDAP5, and the ST-i driver dated in 2013, (the driver just prior to Aug 4, 2016...
Ok, Doug, I located on an older laptop the previous driver dated 9/23/2014. I presume it is the SBIGUDrv.dll. Can I simply plug in the camera, and...
Using 9334 and CCDAutopilot5 with an earlier version the same error occurred. This time, however, I discovered after clearing the CCDAutopilot...
I would like to eliminate each upgrade I did and restore the PC to a point before this error started. Is there a way to roll back the SBIG Aug 4...
Well, I am now also in the access denied club.I have the same setup as Jim and after several hours, CCDAP5 crashed. Same exact error. Win7,...
Doug, I have been helping Jim troubleshoot. The curious thing is that the error is not consistent. It may go three hours, or one before the...
After upgrading to the latest build 10133, images with the ST-i had noise, usually shown as a single or multiple horizontal lines. I wanted to...
Sent it back to Bill today to check out.
Serial # 11586.
Doug, On further testing on the observatory PC and on another PC, the original ST-i consistently timed out so the final verdict is the camera...
Well, the mystery continues... I received my backup ST-i today so I swapped it out for the original ST-i I have been having problems with. The...
Do you think my 28/24AWG cables are sufficient (the one I am currently using if from Monoprice and received the highest rating by at least one...
Doug, In testing the camera, it seems to only fail when autoguding, as far as I can tell. I can take a a series of normal images in continuous...
Separate names with a comma.
