2 Sbig ST4000 (XM and XMC) + internal guide, how do I manage 3 CCD with Maxim?!?!?

Discussion in 'Demo User Tech Support' started by Dario, Sep 14, 2015.

  1. Dario

    Dario Standard User

    Joined:
    Aug 27, 2015
    Messages:
    12
    Location:
    Italy
    Hello everyone and sorry if I can not make myself understood (they are Italian and know little about your language)

    my problem is that I have 2 Sbig ST4000 (XM and XMC) in parallel, to narrow bands and RGB, but also drive with the internal ccd (tot. 3 ccd)

    Maxim DL (I downloaded trial), before you buy, I would like to understand how to manage 3 ccd. I can not do it.

    I tried to start 2 Maxim DL on the same PC (with the simulator works but in reality not), but the second Maxim can not find the second Sbig, can you help?

    How you doing?

    Help !!!

    Thank you
     
  2. Tim

    Tim Staff Member

    Joined:
    Sep 25, 2014
    Messages:
    1,712
    MaxIm DL is designed for controlling only 2 cameras at a time, an auto guider and imaging camera.
     
  3. Dario

    Dario Standard User

    Joined:
    Aug 27, 2015
    Messages:
    12
    Location:
    Italy
    Good morning Tim, this far ok.
    But by starting two sessions on the same PC Maxim, if I had (which I did not) CCD of two different brand, I do find the two programs open to the two Maxim CCD. The problem is that I can not get to choose the USB ports other than Maxim. How is it done?

    Grazie

    Dario
     

Share This Page