How do I setup my STT-8300 to connect to MaximDL via Ethernet?

Discussion in 'Legacy Models - Community Support' started by Hilmi Saleh Al-Kindy, Jan 22, 2015.

  1. Hilmi Saleh Al-Kindy

    Hilmi Saleh Al-Kindy Cyanogen Customer

    Joined:
    Jan 22, 2015
    Messages:
    78
    Hi,

    I have had my STT-8300 for a while now, you might say I was an early adopter. At the time of release the manual only showed the ethernet interface being used for browser control. I am wondering if it can also be used to connect to the camera via Ethernet in MaximDL. If this is possible, how exactly do I set it up?

    Thank you,

    Hilmi Al-Kindy
     
    Hilmi Saleh Al-Kindy, Jan 22, 2015
    #1
  2. Tim Puckett

    Tim Puckett Guest

    See the the attached PDF helps.
    Regards
    Tim
     

    Attached Files:

    Tim Puckett, Jan 22, 2015
    #2
  3. Hilmi Saleh Al-Kindy

    Hilmi Saleh Al-Kindy Cyanogen Customer

    Joined:
    Jan 22, 2015
    Messages:
    78
    Thank you, exactly what I was looking for
     
    Hilmi Saleh Al-Kindy, Jan 23, 2015
    #3

Share This Page