Images showing for split second with ACP

Discussion in 'Image Capture' started by James McCormac, May 18, 2016.

  1. James McCormac

    James McCormac Standard User

    Joined:
    Apr 13, 2015
    Messages:
    4
    Hi,
    Cross post with ACP forum in hope of a solution. I am running Maxim Pro 6 with ACP8 and during automatic imaging the last image from the camera is flashed up for a split second, then it disappears. Occasionally an image named "lastimage" will hang around but this appears to have been heavily binned.

    I would like to see the last full frame image after each exposure and for it to change to the next one after a new image has been taken.

    Has anyone else had this problem? It makes it very hard to check the pointing of the telescope and measure the brightness of a new target to avoid saturation etc. Any advice would be great, thanks

    James
     
  2. Doug

    Doug Staff Member

    Joined:
    Sep 25, 2014
    Messages:
    6,887
    Bob Denny would have to address this.
     
  3. James McCormac

    James McCormac Standard User

    Joined:
    Apr 13, 2015
    Messages:
    4
    Hi Doug, I just found a similar issue and it seems it was something new in ACP 8. You can delete this post if you like. Thanks.
     

Share This Page