ST-i - fix or replace

Discussion in 'Legacy Models - Community Support' started by EricC, Nov 2, 2015.

  1. EricC

    EricC Cyanogen Customer

    Joined:
    Jan 31, 2015
    Messages:
    195
    My ST-i camera smacked into my pier last night and the USB port broke off at the solder joints. I assume the USB cable was jammed into the port. What a bummer.

    Can this be fixed? Either re-soldered or a new board installed? The camera is a little over a year old.
     
  2. Bill

    Bill SBIG Service and Repairs Staff Member

    Joined:
    Oct 12, 2014
    Messages:
    527
    Eric,

    The circuit board can be replaced. Most of the time there is damage done to the board that makes re-attachment improbable and unreliable. Send me an email at bill@sbig.com and I'll give you the details on sending it in.

    -Bill
     

Share This Page