Hello all I tried searching the database and couldn’t find anything regarding this camera and nina, could anyone help me? Frank
It says that SBIG cameras are natively supported in N.I.N.A. right here on their website: https://nighttime-imaging.eu/docs/master/site/requirements/
Thank you for responding Colin, I did read that but the link seems to refer to new cameras, the stl is very old and doesn’t use ascom drivers from what I have found out so far. Frank
Frank, again, go back and re-read the NINA web page. It's not under ASCOM, they added support for SBIG Legacy cameras, using the SBIG Universal Driver. I just verified this is true with my STL-11000M and this is what I see: You should have that in your list.
Confirming - The STL-11000M and filter wheel can attach to Nina (3.1) as a SBIG Legacy device. PHD2 also works with the STL-11Km. Both programs can distinguish between guider and imager CCDs Downloading the full size frame over USB-1 takes ~30 seconds. GL //Tim
Thank you very much Collin and Tim! I appreciate your help, I have successfully used the camera with NINA now, works great. Thanks again. Frank Sowa
For me in Nina 3.1 beta005 there is no mention of SBIG: Is there any thing to add in order to see it?
1. Is the camera attached and powered up? Check the Device Manager for an SBIG camera. 2. Is the SBIG Driver Checker installed? 3. Is the camera seen by the SBIG Driver Checker? eg go to the Firmware Tab, and Get Firmware Version from camera. 4. If all of that is correct, you'll have to ask https://nighttime-imaging.eu/ Maybe you are missing the 64-bit driver we provided for that.
