I'm attempting to use a STL-6303 for an occultation and trying to push it to its limits frame rate-wise. Obviously I'm not going to get better than a few seconds but I was hoping for better than 5 seconds read/deadtime at bin 3 and 64px square image. I was thinking I should get closer to 3 seconds. Any suggestions? Also, in a general sense, any idea what the true shutter speed is? As in, is it 10ms or 1ms etc?
Like the spec says... 0.11 sec min exposure, 10 ms increments. As for cycle time, remember it always has to flush the full array even if it is doing a subframe.
