The Sky X and STL11000

Discussion in 'STF Series CCD Cameras' started by Joel G Parkes, Jul 4, 2015.

  1. Joel G Parkes

    Joel G Parkes Standard User

    Joined:
    Oct 15, 2014
    Messages:
    6
    Hi
    I recently installed an STi as a remote guider following all the steps to set up new drivers. My STL imaging camera was also set up and works in MaxIm. However now I cannot connect my STL to SkyX Camera addon sending an error "camera not found". I used to use this all the time before to set up TPoint data. Any thoughts?
    Joel G Parkes
     
    Joel G Parkes, Jul 4, 2015
    #1
  2. Joel G Parkes

    Joel G Parkes Standard User

    Joined:
    Oct 15, 2014
    Messages:
    6
    Partial success from info at SkyX. The first CCD is set ti USB1, the second to USB2 etc. Used these under Settings and both STL and STi connected successfully.
    Joel
     
    Joel G Parkes, Jul 6, 2015
    #2

Share This Page