Doug, I will check again. Could you also provide the spec of the fan? I am looking for alternative on the market.
Thanks! This does seem a common issue. Actually I joined a remote team and their 16803 started to show similar issue, and they suspected it was...
And is there any compatible low vibration fan in the market? I could try a different fan.
Doug, Are you talking about 4 black screws, or silver screws? I removed 4 black ones and fan just came off, nothing to hold it. When I power on...
I dont have picture of my setup in front of me. I will post later. It is FSQ106ED+FT focuser+16200 on AP1100. Do you have instruction how to...
And for this type of problem, you should put it in a sticky Q&A thread, for anyone has similar issue can find it quickly.
Stars looked great if I turned of cooling and fan (but image is very noisy so hard to tell). With 30% fan speed, fan seemed quiet but stars did...
How do I know if "undervoltage protection" has been triggered?
Doug, What is the impact on setting fan speed too small? Is it going to cause any potential damage to the sensor? And what is the rule of thumb...
I checked SGPro does not have fan speed option.
Doug, Has this been fixed in either firmware update or some other form? I think this is exact problem I have been struggling. I got almost...
I can feel that it gets loose a bit but I am not sure whether it will be too loose to lock sensor/prsim. I dont know how it will go during...
BTW, it appears to me that lock screw tends to get loose over time. After adjusting prism and sensor location, I want to use some type of glue or...
Got it. It will save the battery too. It is 8A at 100% cooling so not many battery can last in winter night.
Then why dont you limit the cooling capability to 80% instead? I can get to -35C easily for most summer nights (eg, I got -35C with 60% cooling...
One more question: does SBIG driver restrict cooling to -35C max? I set cooling to -40C in SGPro but it stopped at -35C. I remember seeing...
Doug, Thanks! I will dig further. I think Ha filter might be worse than others? Any potential cause why this would happen.
The star trail in image appears to be more top down, so means sensor tilts a bit forwards or backwards.
X17110005. If it has been shimmed in manufacture then I might have misplaced shim and shim sheet. Is it possible you send shim sheet and same...
Or could the tilt come from self guided cover?
Separate names with a comma.