Exactly. The focus dial is as far as it can go, and it needs a little more travel to get to focus. But that was not an issue with the refractor.
Hi Colin: So per above, I made sure it wasn't me overshooting the focal point. Attached is a screen shot of typical results - - that's about as...
So it's not a USB power issue - - as expected, I had already configured them to not power down. And I have not been able to find any CrashDumps...
I'll check, but I don't think it's a USB power issue - - I've been into the settings before with other equipment, and I think I've set it up to...
That's a good point about the site and scope configuration - - I set it up for the NP101, but haven't added the specs for the SCT yet - - I'll do...
And I forgot - - there's a Celestron T adapter (obviously) between the Edge and the camera assembly, threaded into the AO-8A.
Initial Setup: Televue NP101, F5.4 Stock focuser No focal reducer, but used with and without 2x Barlow 2" Televue extension tube to reach focus...
Hi Colin: So far my experience of this package has been a bit mixed, and I'm still trying to figure out how much is me, and how much might be...
Didn't get a chance to install the AO unit yet, but STC7 and SC work great now. And I did not have to use the straight through cable between the...
Hi Colin: Couple things: USB looked good, as you described. I proceeded to do a bench test (all I'm able to do tonight), and no change. Then...
So, good news / bad news: good news - - updating Maxim DL to 6.26 fixed the "camera not initialized" error, and the software successfully...
Hi Colin: currently running 6.26 on Maxim DL (i.e., LT version), driver version seems correct: "2.0.2.0". Thanks for your prompt help!
Purchased the STC7 camera package with SC2 and AO. After successfully bench testing the camera and filter wheel, I proceeded to the next step to...
Separate names with a comma.
