Ok, likely it is the normal hum associated with the shutter motor being held in position, and nothing to worry about. You might want to check if...
That seems a bit unusual. Can you provide the serial number of the camera and filter wheel? Was the cooler on or off? Are you using the original...
Yes. Unplug it. Install SBIG Driver Checker. Update Drivers. Quit. Plug it in. Launch Driver Checker. Firmware Tab - Get Firmware version from...
They are compatible.
You can find the manual under the +DOWNLOADS on the camera page here: https://diffractionlimited.com/product/aluma-ac4040/ Thank you for the...
Adapter will go INTO the round part of the D-BLOCK, so a collision is fairly unlikely. Bill sent you the correct screws. I'd just use them. My...
Start with a setpoint of -15C. The CMOS Active Pixel Sensors heat up a lot during the readout process, and even when idle soaking up photons, the...
I think PHD2 uses our drivers, not ASCOM, for AO.
It's reading out both High and Low Gain channels, showing you the low gain below the high gain in one 8k x 4k image. Note that you can play with...
Correct.
The first camera, Camera 1, the main detector, DL Imaging needs to be AC4040 *. The second camera, Camera 2, the guider, needs to be SCE1300 *....
Go to the Camera Control Window Camera 1: [Setup Camera] Camera Model = DL Imaging [Advanced...] This will bring up the list of cameras seen by...
At Precise Parts, why don't you pick one of these: (Top pick listed first): a) SBIG D-Block - this gives something that will insert into the...
Perhaps my colleague @Tim who handles repairs may be able to assist.
Here's a picture with the various dimensions. [ATTACH]
There are 2 usual ways to attach a midsized SBIG camera: a) T-thread. SBIG T-threads are camera industry standard T2 threads which are M42 x 0.75...
Just chiming in here - one important thing is the Pinout diagram in the manual is like you are looking INTO the CAMERA body. So be careful. I...
Thank you.
In DL Config Utility, please do HELP ABOUT and give me a screen shot of that. It will show the versions of the components. Like this: [ATTACH]...
Chuck, for us to figure this out, we need a few simple details: 1. Settings Please zip up your MaxIm Settings folder including subfolders, and...
Separate names with a comma.
