The off-axis guider needs to be behind the AO. It won't work otherwise. As soon as there's an offset, the AO will tilt to try and correct it,...
Very nice! You're certainly making good use of the camera! Can't wait to see the final version.
Nice thing about AO is it'll work as long as the calibration is in the ballpark. Ideally, though, you'd want it to be accurate. I'm planning...
The AO won't tilt 45 degrees during calibration. It will be pretty close to up/down and left/right. Unless you somehow have the AO attached at a...
Good to know on Bin 1 versus Bin 2. It's hard to simulate this properly in the shop. If we can get some clear skies here I'll do some testing,...
None of our dealers stock desiccant plugs, so they have to order from us, receive it, and then send it along to you. We do have an order from...
Re StackPro calibration, in addition to Light, Dark, and Flat you will need matching Flat-Darks. Calibration will work normally despite the...
Nice image!
For SC-3, counterclockwise = focus is all the way in. Therefore moving the mirror outwards from the optical axis should shorten the distance to...
It would take me an hour to pull up the drawing. I'd have to set up an old computer to run the old software. Pretty sure it's 4-40.
The fuses are in the camera. We don't have any boards left. The repair is straightforward for anyone with experience in surface mount soldering.
User manual says 0.92". https://diffractionlimited.com/wp-content/uploads/2016/03/USBmanRev14.pdf - Page 37
It's already been added, and will be released with the next minor update. Assuming all goes well it should be released in December.
Yes, @Tim will provide.
I found the CFW serial interface developer's kit and posted it: https://cdn.diffractionlimited.com/downloads/CFW10DevKit_1r0.zip
I recommend returning the camera for service.
Yes, the chamber was opened; however, we have a process to handle that safely with windowless sensors. A temporary sensor window is installed....
Still looks like frost to me.
Reporting the wrong camera model indicates that the EEPROM has been corrupted. That is probably fixable. The all zero image is concerning...
Here are McMaster part numbers for the O-rings used in the ST-2000 housing: 9557K67 (there are two of these) 9557K125
Separate names with a comma.
