We are integrating STF8300M into our product. In the manufacturing process we are fine-tuning each camera to generate the same ADUs of a target slide with a range of light signal, by changing integration time. Some of the cameras have too much of a gain in order to fit within our allowed error margin on each end of the signal range. We put these cameras aside as "Bad camera". If it would be possible to change the gain characteristic of these cameras, then we would not accumulate bad cameras on the shelf. I went through the driver interface manual but I couldn't find any knob to be turned in this regard. Can you please advise? Elizabeth
This is not normally user-adjustable, but it can be done with a special software tool. Since you are an OEM customer we can probably arrange that. Please provide your email address by Private Message.