SC4 and Maxim v6.4

Discussion in 'Guiding and Adaptive Optics - StarChaser and AO' started by Martin Pugh, Jan 20, 2024.

Page 5 of 5
  1. Martin Pugh

    Martin Pugh Cyanogen Customer

    Joined:
    Oct 27, 2014
    Messages:
    423
    I do think my AO is not functioning correctly. Every time I calibrate I get a different set of results, suggesting it is sticking.

    are you able to calculate what the approximate calibration vector values should be if the focal length is known?
     
    Martin Pugh, Sep 17, 2024
    #81
  2. Colin Haig

    Colin Haig Staff Member

    Joined:
    Oct 27, 2014
    Messages:
    8,077
    Location:
    Earth
    Yes, sounds like it is sticking.
    Great question. Not easy to answer.
    I'm going to think about that - focal length, arcseconds per pixel, pixel size, and distances are likely ingredients.

    My foggy recollection is full deflection on the order of perhaps +/- 10 to 20pixels off center in both axes for a 9um pixel.
    In other words, deflection +X / -X should be almost identical (call it a distance of "DX"), and +Y / -Y should be almost identical ("DY"), and DX and DY are close to the same.
     
    Colin Haig, Sep 18, 2024
    #82
  3. Martin Pugh

    Martin Pugh Cyanogen Customer

    Joined:
    Oct 27, 2014
    Messages:
    423
    Here is an example of what I am seeing:
    Image 6377 is prior to exercising the AO, and Image 6378 taken immediately after.
    As you can see Pos 1 and 2 differ in X.
     

    Attached Files:

    Martin Pugh, Sep 18, 2024
    #83
  4. Martin Pugh

    Martin Pugh Cyanogen Customer

    Joined:
    Oct 27, 2014
    Messages:
    423
    what you would recommend that I apply to the moving parts inside the AOX? Perhaps a little bit of silicon applied with a q-tip or some other type of lubricant?
     
    Martin Pugh, Sep 18, 2024
    #84
  5. Doug

    Doug Staff Member

    Joined:
    Sep 25, 2014
    Messages:
    10,365
    Do not lubricate anything in the AO-X. The bearings are permanently lubricated and nothing else should be in contact during operation.
     
    Doug, Sep 19, 2024
    #85
  6. Martin Pugh

    Martin Pugh Cyanogen Customer

    Joined:
    Oct 27, 2014
    Messages:
    423
    ok....if it is sticking, how do I resolve that?
     
    Martin Pugh, Sep 19, 2024
    #86
  7. Doug

    Doug Staff Member

    Joined:
    Sep 25, 2014
    Messages:
    10,365
    I'd first pull it off the telescope and visually observe the optic while exercising, to see if it is behaving properly. If not then it will have to come in for service.
     
    Doug, Sep 19, 2024
    #87
Page 5 of 5

Share This Page